30-Sep-99: 1/8" copper tubing connects the electric valve, above the gascolator to primer ports on three cylinders. This is connected with steel T fittings supported by adel clamps.

30-Sep-99: Oil & fuel pressure sensors. The third position on the sensor manifold is for engine manifold pressure. Starter solenoid in background.

30-Sep-99: Van's issued a service bulletin requiring reinforcement for the rudder pedal assembly. Eric Andersen, EAA Chapter 18 President, kindly did the welding. The assembly was not easy to remove & refit!

23-Oct-99: MAP module to left of regulator. A DB9 connector is wired to the EIS-4000 engine monitor. Nyloflow tubing goes through the firewall to the sensor manifold, then a -4 hose to the #3 cylinder port.

29-Oct-99: Fuel flow sensor connected between the gascolator & engine fuel pump. Fire sleeve on the 3/8" Al main fuel lines & also on the 1/4" Al line to the primer solenoid.

22-Nov-98: Aeroflash wing tip light modules fitted, wired & tested.